Adjusting belt tension

To adjust belts that are tensioned with bolted brackets, rather than an automatic tensioner, it’s best to use a tension gauge, which is calibrated in pounds. Follow these steps:

· Loosen the mounting bolts that hold the alternator, A/C compressor or fan hub in place.
· Depress a knob on the gauge and assemble it around the belt, with the two stationary prongs on the inside of the belt and the movable one on the outside.
· Release the knob. The dial will rotate and show the tension in pounds.
· Turn the adjusting bolt one way or the other to increase or reduce tension in accord with the tension listed in the gauge guide or in your engine owner’s manual.
· Once tension is correct, tighten the attaching bolts and recheck.
If testing with your thumb, you should be able to depress the belt no more than its thickness in a short span, one foot or less, or no more than twice its thickness in a span of two feet or more.

With a standard V-belt tensioned with bolted brackets, set the tension at the maximum recommended for a new belt. After about 3,000 miles, the belt may stretch slightly, so recheck tension.

Before removing a serpentine belt to install a new one, note its routing around the crankshaft, various accessories and the automatic tensioner. To remove the old belt, rotate the tensioner to reduce tension.

Showcase your workhorse
Add a photo of your rig to our Reader Rigs collection to share it with your peers and the world. Tell us the story behind the truck and your business to help build its story.
Submit Your Rig
Reader Rig Submission